ROWENTA MASTER VALET GARMENT STEAMER IS6300 - Manual (Page 26)

21
handle while the panel is rolling back to the top.
WARNING: never let go of the handle until the panel has totally rolled back.
Once the appliance is switched off, it is recommended to wait several minutes so that the
Roll & Press panel has dried before rolling it back.
• Empty and rinse the water tank each time before storage in order to flush out any scale
particles (fig. 22).
• Loosely wind up the electrical cord and close with the Velcro strip, then hang it from the clip
on the pole (fig.23 - fig. 24).
• Do not carry the steamer by the water tank handle. This appliance includes luggage style
wheels for added convenience when transporting.
WARNING: Never touch the head until it has cooled down completely.
1 • Transport
• Your appliance is fitted with two wheels for ease of transport. Tilt the appliance towards the
rear holding the pole and then pull along to transport.
• You can also lift up the appliance in order to transport it, again holding the appliance by
the pole.
Do not attempt to lift up or transport the appliance holding the Roll & Press panel, the pedal,
the water tank handle or the built-in hanger. Always roll back the Roll & Press panel before
transporting the appliance. Always make sure the pole is firmly attached to the base unit
before lifting up the appliance (see assembly instructions).
2 • Cleaning
• Clean the main unit with a damp cloth.
• Clean the Roll & Press system panel with a damp cloth or non abrasive sponge.
Do not use any cleaning products such as soap or detergents.
• Always handwash the delicates steam cap and wait until it is totally dry before using again.
• To maintain maximum performance, your steamer must be descaled occasionally.
The time between descaling operations depends on the quality of the water and the
frequency with which you use the appliance. The appliance must be descaled at least once
a year or after 50 hours of use.
• To carry out a descaling operation, follow the following steps:
1. Ensure that the appliance has cooled down completely (2 hours minimum).
2. Fill the water tank with fresh untreated tap water and place it on the main unit
allowing water to fill the boiler.
3. Remove the water tank from the base and empty out the water via the water tank
filling hole by tipping the appliance over a sink. Limescale and other impurities can
be rinsed away.
4. Repeat step 2 and 3 several times until all the scale has been removed.
CAUTION: Don’t fill the boiler by the steam head holes!
Never immerse the steam head in water!
9100021244-01 IS6300 D1.indd 21 11/07/2016 09:42