Epson EMP-TWD10 - Manual (Page 8)

6
Class 1 LASER Product
Do not open the top cover. There are no user serviceable parts inside the unit.
Do not use the unit in places where there are lots of humidity or dust, near cooking or heating
appliances, or in places where it may come into contact with smoke or steam.
Do not use or store this unit outdoors for an extended length of time.
Fire or electric shock may result.
Do not block the slots and opening in the unit case. They provide ventilation and prevent the unit from
overheating.
• Material or paper may get stuck against the air filter underneath the unit while it is in use. Remove
anything from underneath the unit that might get stuck against the air filter. If setting up the unit near a
wall, leave a space of at least 20 cm between the wall and the air exhaust vent.
• Ensure there is at least 10 cm between the air intake vent and any walls, and so on.
• Do not place the unit on a sofa, rug, or other soft surface, or in a closed-in cabinet unless proper
ventilation is provided.
Do not place the unit on an unstable cart, stand, or table.
The unit might fall down or tip over, and injury may result.
Do not stand on the unit or place heavy objects on it.
The unit might collapse or fall down, and injury may result.
Do not place anything that can become warped or damaged by heat near the air exhaust vents, or
bring your hands or face close to the vents while projection is in progress.
Because hot air comes out from the air exhaust vents, it may result in burns, warping or other accidents.
Never try to remove the lamp immediately after use because it will be extremely hot. Before removing
the lamp, turn off the power supply and wait the duration specified in this guide to allow the lamp to
cool completely.
The heat may cause burns or other injuries.
Do not place the source of a naked flame, such as a lit candle, on or near the unit.
Unplug the unit when it will not be used for extended periods.
The insulation may deteriorate, which may result in fire.
Be sure to check that the power is turned off, the plug is disconnected from the outlet and all cables
are disconnected before moving the unit.
Fire or electric shock may result.
Caution
Do not
disassemble
Do not do
Do not do
Do not place
on an
unstable
surface
Do not do
Do not do
Do not do
Do not do
Disconnect
the plug from
the outlet
Disconnect
the plug from
the outlet