Eltax DV-150 - Manual (Page 6)

THE REMOTE CONTROL
Loading batteries to the remote control
Remove the battery compartment cover.
Make sure that the batteries have been inserted
in the correct polarities matching to the symbols
+, - marked in the battery compartment. Close
the battery compartment cover.
When replacing batteries, replace both batteries.
Do not mix new and used batteries operating
together, otherwise, the operation lifetime will
be much shorter than normal.
Remove the batteries if the unit will not be used
for a prolonged period of time.
The remote control transmits a directional
infrared beam.Be sure to aim the remote
control directly at the infrared sensor of the
unit during operation.
If the sensor has been covered or there is a
large object between the remote control and
the sensor, the sensor will not respond.
The sensor may not able to receive the
remote signal when it is exposed to direct
sunlight or a strong artificial light (fluorescent
or strobe light). In this case, change the
direction of the light or reposition the unit to
avoid direct lighting.
ˇ
ˇ
ˇ
ˇ
ˇ
Load two AAA (UM-4 or R03) batteries into the
battery compartment.
INTRODUCTION
Do not dispose of batteries as normal rubbish. Be environmentally friendly,
dispose of batteries following the Government's regulation.
BE ENVIRONMENTALLY FRIENDLY
Within approximately
6 meter (20 feet)
30 30
DV-150 DVD-PLAYER
STANDBY
P/N MUTE
EJECT
PROG
SEARCH
SUBTITLE
ANGLE
SETUP RETURN
ENTER
TITLE MENU
CHANNEL LANGUAGE
RESET REPEAT MARK CLEAR
MODE PSCAN A - B SLOW
DISPLAY SHUFFLE SHUFFLE VOLUME
6