Maintenance and cleaning, Daily or weekly cleaning performed by the user, Brazier cleaning – MCZ Club HYDRO 15 kW User Manual
Page 31: Ash tray cleaning
PELLET STOVES
Chapter 5
INSTALLATION AND USE MANUAL
page
31
Maintenance and cleaning
Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
F
G
6. MAINTENANCE AND CLEANING
Only a proper maintainance and cleaning of the product can assure you
the correct functionality and a safe use of your stove.
ATTENTION!
All the cleaning operations of all parts must be
performed with the product completely cold and the
plug disconnected.
Disconnect the product from the 230V power supply
before performing any maintenance operation.
The product requires little maintenance if used with certified
high quality pellets.
6.1. DAILY OR WEEKLY CLEANING PERFORMED BY
THE USER
6.1.1.
Brazier cleaning
Before ignition, always clean the “T” brazier and remove any ash or
incrustation from it that might obstruct the air flow holes, paying
attention to hot ash. In the case of ignition failure, or if fuel in the tank
runs out, unburned pellets may accumulate in the brazier. Always
empty the residue in the brazier before each start-up. Only if ash is
completely cold may a vacuum cleaner be used to remove it. In this
case, use a suitable vacuum cleaner to remove small sized particles.
REMEMBER THAT ONLY A CORRECTLY POSITIONED
AND CLEAN BRAZIER CAN GUARANTEE THE IGNITION
AND OPTIMAL OPERATION OF YOUR PELLET
PRODUCT. IN CASE OF FAILED IGNITION AND AFTER
ANY OTHER LOCK STATE OF THE PRODUCT, IT IS
ESSENTIAL TO EMPTY THE BRAZIER BEFORE
PROCEEDING TO RESTART.
IF IGNITION FAILS (A01), IT IS IMPORTANT TO
REMOVE THE PELLETS LEFT IN THE BRAZIER BEFORE
REPEATING THE IGNITION OPERATION.
For the brazier to be cleaned properly, remove it from its housing
completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to
use a brush to restore the optimal operating conditions of the
component.
6.1.2.
Ash tray cleaning
Remove and empty the “G” ash tray. Wipe away any residual ash
before reinserting the tray. Your experience and the quality of the
pellets will determine the ash tray cleaning frequency. However, it is
recommended not to exceed 2 or 3 days.
Example of clean grate
Cleaning the ash collection compartment
Example of dirty grate