MCZ Forma GAS 115 - Manual (Page 31)

FORMA GAS 55/75/95/115
USER MANUAL page
4
Technical service – MCZ S.p.A. all rights reserved - Reproduction prohibited
5.3 Replacing empty batteries
 Handset: if the indication BATT appears in the top left corner of the display screen, the batteries of the
remote control unit need to be replaced.
 After replacing the battery in the handset, the settings of the thermostat and timer function have been
reset to the factory settings. (see paragraph 7)
 Receiver: 3 short sound signals will be heard when the engine is on to indicate that the batteries of the
receiver are nearly run down.
 When the battery supply is very low, the remote control unit will switch off the appliance completely.
This will not happen if the supply is interrupted.
 It is possible that the transmitter code will have to be set again after replacing the batteries, see
paragraph 5.2 for instructions.
6. Setting the controls on the remote control unit.
Time setting:
 Press the - and the -key simultaneously (fig. 1.4)
 The display screen will blink now
 Press the -key to set the hours (fig. 1. 9)
 Press the -key to set the minutes (fig. 2.0)
 Wait or press the OFF- key to terminate this function (fig. 1.8).
Setting the transmitter code on the remote control unit:
 Press the reset button of the receiver with a pointed object (fig. 2.3.1), until the second signal is audible.
Now press the -key on the remote control unit (fig. 2.0), within 20 seconds. If a sound signal is audible,
the transmitter code has been set.
Temperature/clock setting (standard °C/24hours):
The alteration of the temperature indication on the display screen from °C/24hours to °F/12hours and
the other way around is done in the following manner:
 Press the OFF-key and the -key (small flame) simultaneously until the indication is modified (fig. 1.5).