EarthQuake IQ-1500R - Manual (Page 9)

Amplifier Specifications
9 Specifications Are Subject To Change Without Notice
POWER OUTPUT
FREQUENCY RESPONSE
TOTAL HARMONIC DISTORTION
SLEW RATE
SIGNAL TO NOISE RATIO
LOAD IMPEDANCE
DAMPING FACTOR
CONTROLS
INPUT CONNECTIONS
OUTPUT CONNECTIONS
MODE SWITCHES
PROTECTION CIRCUITRY
POWER REQUIREMENTS
IQ-600R=10A
SIZE AND WEIGHT
1 x 1100watts RMS @ 4 ohms Mono (1% distortion)
1 x1500 watts RMS @ 2 ohms Mono (1% distortion)
1 x 700 watts RMS @ 8 ohms Mono (1% distortion)
20Hz-2kHz
<0.08%, (1W/4ohm)
55 volts / microsecond
> 106dB (balanced) 105dB (unbalanced) @ rated power
2 ohms or greater
> 500
XLR / RCA • High-level
Binding posts • Locking mechanism
Phase switch 0° / 180° - Variable time delay 0 to 20 millisecond
Short circuit, open circuit, RF burnout, over temp,
protection, DC protection, limiter circuitry
turn on/off transient
Power • Room equalization • Room equalization IN/OUT • Subsonic
filter • Phase shift • Lowpass, Bypass • Channel and power status
LEDs • Dual gains internally mixed • Music sensing ON/OFF • DC
turn ON/OFF
110-120VAC~/60Hz
H=1.7" x W=19" x D=14.5"
44mm x 483mm x 367mm
26.04lbs. • 12.2Kg
IQ Subwoofer Power Amplifier