Elinchrom D-LITE 2 IT - Manual (Page 19)

SET Config Mode:
(to configure included features only with MAC°/ PC° EL-Skyport Software V. 3.0)
- Switch the module OFF // remove battery..
- Hold the Test button down whilst you insert the battery..
- Keep test push button pressed until STATUS LED is ON.
 Please check also EL-Skyport PC/MAC software 3.0 for changing Transmitter setting.
EL-Skyport Eco Features
Power save mode timer:
- After not using the Transmitter for 30 minutes the Power Save mode is active. To reactivate the
Transmitter, press the TEST push button.
- The Power Save mode timer can be configured with the EL-Skyport PC/MAC software v3.0 and higher.
Status LED:
- LED flashes every 4 seconds one time in “Standard” mode and two times in “Speed” mode.
- LED intensity correspond to the battery status - if off or very low =>exchange the battery.
- LED is OFF if the Transmitter battery is discharged or in “Power Save” mode.
.
Reset to manufacturer default setting:
- Switch the module ON // insert battery.
- Press test button for min 10 seconds.
Note:
“GROUP” settings are not available for the EL-Skyport ECO Transmitter.
18
English