Meliconi AD Professional LTE - Manual (Page 2)

3
GB
A
B
INDOOR AMPLIFIED ANTENNA
FOR DIGITAL TERRESTRIAL SIGNAL
“AD PROFESSIONAL”
USER INSTRUCTIONS
Thank you for choosing MELICONI.
The AD PROFESSIONAL indoor amplified antenna receives digital terrestrial TV
and DAB radio signals, as well as traditional analogue signals on the UHF and VHF
(band III) bands.
Secure the plastic support included in the kit to the body of the antenna using the special
screw (fi gure 1).
The antenna can be positioned horizontally or vertically on a fl at surface (fi gure 2) or
wall-mounted.
Proceed as follows to mount the antenna on a wall:
a. Hammer two nails with head diameter of approximately 6 mm into the wall. The
distance between the two nails should be 38 mm (1.5 inches).
b. Insert the heads of the two nails in the special plastic support holes at the back of the
antenna (fi gure 3).
Note: The antenna should be located at a safe distance from metal objects, electrical
equipment and reinforced concrete walls to ensure optimum functioning.
Positioning the antenna
The AD Professional is used to receive digital signals – using a digital terrestrial decoder
or a TV with built-in digital tuner - and traditional analogue signals – on traditional TV
sets.
- Connect the Meliconi antenna cable to the socket at the back of the digital terrestrial
decoder or the television . If the decoder's antenna outlet is the F-female type, obtain
an F-male IEC-female adaptor (not included).
- Use the AC/DC adapter included in the kit to power up the antenna. Insert the cable in
the antenna power supply input and connect the adapter to the mains power supply .
Alternatively the decoder may be designed for the power supply to be provided directly
by the antenna cable (see the decoder user manual).
- Switch ON the antenna using the wheel located on one side of the antenna.
- Check that the red LED on the front of the antenna is switched ON. This means that
the antenna is powered up correctly.
- Switch ON the digital terrestrial decoder and/or the television and select the channel
required.
Installation