MINOURA LiveRide LR240 - Manual (Page 4)

3.
Fully open both legs and place LR240
on a flat and level floor. (see Fig. B)
At this moment, make sure all 4 foot
are contacting the floor at once to sit on
the floor stable.
How To Setup Your LR240 Trainer
2.
Install the Roller Pressure Adjust Knob set (MF-3)
to LR240 frame.
First, remove the pre-installed bolt and nut from
the frame. (see Fig. A-1)
Insert the Flat Washer and Acorn Spring into the
Knob Bolt first, then screw the knob set to the
Plate Nut coming from behind the bracket on the
frame. (see Fig. A-2)
- 4 -
1.
Replace your rear wheel quick release skewer to the supplied one.
Minoura guarantees the stability only when using the supplied skewer due to the coupling inner
shape.
! If your bike is not equipped with quick release skewer and it's a hub nut type,
replace the left side coupling (UF-8) to the optional "Left Side Coupling for Hub
Nut Axle".
Minoura doesn't guarantee the stability if you don't replace the left side coupling.
You don't need the supplied quick release skewer if your wheel is a hub nut type.
It's not possible to convert your wheel from the hub nut type to the quick release
skewer type unless replacing the hub.
!
Required Tools: 1 x 10mm Spanner
1 x M4 Hex Wrench
! If you feel some difficulty
of the vertical action of the
Mag resistance unit, slightly
loosen the pivot bolt which
connects the Mag unit to the
frame.
Do not over-loosen the pivot
bolt. It may cause injury to
your finger when the Mag
unit suddenly drops down.
!
Make sure the Acorn Spring
direction is as shown in Fig.
A-2.
Failure will cause difficulty
on rotating.
(Fig. A-2)
(Fig. B)
(Fig. A-1)
Remove Bolt and Nut
Plate Nut
Knob Bolt
Flat Washer
Acorn Spring