Extron electronic MMX 42 - Manual (Page 20)

MMX 42/62 Series Matrix Switchers • Remote Control
Remote Control, cont’d
MMX 42/62 Series Matrix Switchers
A
Appendix A
Specifications
Accessories and Part Numbers
Specifications
Included Parts
Accessories
Cables
4-12
3. Click on Upload Firmware File. A dialog box asking you
to select the update file is displayed (see Figure 4-7).
Figure 4-7 — Select update file box
4. Click OK. When the Browser window (figure 4-8) opens,
find the updated firmware file (where you previously
saved it) and select the file, then click Open to load it.
Figure 4-8 — Browser window
The firmware update file must have an .s19 extension. If
it doesn’t have that extension it will not work properly.
5. The firmware is updated as the file loads. When the
update is complete, a dialog box will open, asking you to
exit the utility program if the new firmware version is
correct or to run the utility again if it didn’t load correctly.
Click Okay to complete the process (the LEDs on your
MMX switcher will cycle through the power on sequence).
Your switcher is ready to use.
Using the help system
For information about program features, you can access the help
program in any of the following ways:
• From the Extron Electronics program group, double-click
on the Universal Switcher Help icon.
• From within the Windows-based switcher control
program, click on the Help entry on the task bar.
• From within the Windows-based switcher control
program, press the F1 key.