MINOURA MoZ-Roller - Manual (Page 3)

Roller Drum
Roller End Cap (universal for R & L sides)
Roller Belt
Adjuster
Dome Nut
Spring Washer
Flat Washer
Metal Collar
Bridge Frame
Wheelbase
Adjust holes
SCHEMATICS
Adjuster Collar
WARRANTY
Minoura provides limited warranty service to the first orginal user who purchased the product at Minoura authorized
retailer in brand-new/unopened condition. The warranty period is maximumly 1-year on this product.
However, any Minoura non-related problems such as unauthorized modification, abuse, trouble during shipment, and
natural wear will not be covered by this program.
Any used product gotten through auction or person-to-person trade is void the warranty service.
Even if it's purchased in brand-new condition, if you cannot present us the copy of the purchase reciept issued by the
shop, it will be handled as a "used" one.
For more information, refer the attached "Minoura Limited Warranty Policy" card and visit Minoura's web site.
Lock Lever
(only on Right frame)
Anti-Slip Rubber
Caution on Direction of Metal Collar
Frames are universal for right and left side, except the existence of Lock Lever. Therefore, the larger hole
is always located on the left side for both frames. Insert Metal Collar from the larger left side hole.
Metal Collar reinforces the frame against the tightening power by the nut. The frame will have to be
damaged if you don't use Metal Collar, so don't miss it.
Do not forget to put a Flat Washer between Roller Drum and Frame on both sides Axle.
!
- 3 -
Dome Nut
Spring Washer
Flat Washer
Metal Collar
About Adjuster
Adjuster works to adjust the height. If all roller drums won't become parallel when place rollers on the floor
and apply some load, extend Adjuster(s) to level the rollers.
After changing the adjuster length, tighten the lock nut toward Adjuster Collar to lock the Adjuster position.
!
About Anti-Slip Rubber
Put the rubber sheet on top of Mid Frame on the side you usually place your leg.
When using the optional Foot-Step at all times, you can change it to opposite side.
!
Rear Frame Mid Frame
Front Frame
About Roller-Belt
MOZ-Roller is different from any other rollers. The roller end cap is universal so you can put Roller-Belt to
any side you like.
!
Flat Washer
Flat Washer
Axle
Nylon Nut
About Bearing Holding Nut
From ver.1.2, the bearing holding nut has been changed to a Nylon Nut to avoid loosening. Therefore, you
need to remove the flat washer from the front roller when installing an optional Front Guard.
!