Em-301_side 2, Mic hf redial flash auto store hold, Warranty information (cont.) – Emerson EM301 User Manual

Page 2: Warranty information product maintenance, Troubleshooting tips, Telephone operation, Location of controls, Installation (cont.)

Advertising
background image

Limitation of Warranty:
● THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY

APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE)
ARE HEREBY DISCLAIMED. NO VERBAL OR WRITTEN
INFORMATION GIVEN BY SOUTHERN TELECOM INC. IT’S AGENTS,
OR EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY
INCREASE THE SCOPE OF THIS WARRANTY.
● REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY
IS THE EXCLUSIVE REMEDY OF THE CONSUMER. SOUTHERN
TELECOM INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR
IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER OF
WARRANTIES AND LIMITED WARRANTY ARE GOVERNED BY THE
LAWS OF THE STATE OF NEW YORK. EXCEPT TO THE EXTENT
PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON
THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY
PERIOD SET FORTH ABOVE

Some states do not allow the exclusion nor limitation of incidental or

consequential damages, or limitations on how long an implied warranty

lasts so the above limitations or exclusions may not apply to you. This

warranty gives you specific legal rights, and you also may have other rights

that vary from state to state.

www.emersonphones.com

Manufactured by AIT Inc. Brooklyn NY. 11232

Emerson and the G-Clef logo are registered trademarks

of Emerson Radio Corp. Parsippany, New Jersey USA.

© 2009 AIT Inc.

All rights reserved.


Warranty Information (Cont.)

1 Year Limited Warranty

In the unlikely event that this product is defective, or does not perform

properly , you may within one (1) year from your original date of purchase

return it to the authorized service center for repair or exchange.
TO OBTAIN WARRANTY SERVICE:

● Provide proof of the date of purchase within the package

(Dated bill of sale).

● Prepay all shipping costs to the authorized service center, and

remember to insure your return.

● Include a return shipping address (no P.O. Boxes), a telephone

contact number, and the defective unit within the package.

● Describe the defect or reason you are returning the product.
Your product will be repaired or replaced, at our option, for the same or

similar model of equal value if examination by the service center

determines this product is defective. Products received damaged as a

result of shipping will require you to file a claim with the carrier.
The shipping address of the authorized service center is:
Southern Telecom Inc.

ATTN: Returns Department

14-C 53rd Street

Brooklyn, NY 11232
Should you have any questions or problems concerning this product, please

contact our customer service department, toll free at:

1-877-SOUTHTEL (1-877-768-8483)

Monday – Thursday: 9AM – 5PM (EST)

Friday: 9AM - 3PM (EST)

or via email at [email protected]. To obtain service after the

warranty period, please email [email protected] with product

information,date of purchase and nature of the problem. Customer service

will reply to the email with service instructions.
Warranty service not provided

This warranty does not cover damage resulting from accident, misuse,

abuse, improper installation or operation, lack of reasonable care, and

unauthorized modification. This warranty is voided in the event any

unauthorized person opens, alters or repairs this product. All products

being returned to the authorized service center for repair must be suitably

packaged.

Warranty Information

Product Maintenance

Follow the guidelines below to properly maintain this product:

● Avoid putting it near heating appliances and devices that generate

electrical noise (for example: motors or fluorescent lamps).

● DO NOT expose to direct sunlight or moisture.

● Avoid dropping the unit and/or other rough treatment.

● Clean with a soft cloth

● Never use a strong cleaning agent or abrasive powder because this will

damage the finish.

● Retain the original packaging in case you need to ship it at a later date.

Troubleshooting Tips

No dial tone - Check to see if your phone is properly connected to the

modular wall jack. (Refer to

Installing Your Telephone).

Phone doens’t ring - Make sure the [RINGER ON/OFF] switch (located

at the back of the base) is set to the ringer ON position.

Handset volume is low - Adjust the [HANDSET VOLUME] switch to the

MID or HI position.

Speaker volume is low - Adjust the [SPEAKER VOLUME] switch to the

desired volume level.

Memory Dialing

This telephone can store up to 10 phone numbers (up to 16 digits), which

will remain stored in memory unless you erase or change them by entering

other numbers, or unplug your telephone from the wall jack.
To Program Numbers Into Memory
1. Lift the handset.
2. Press the

[STORE] button.

3. Dial the number you would like to store (up to 16 digits).
4. Press the

[STORE] button.

5. Enter a digit

[0 - 9] for the memory location where you want to store the

number.
To Dial Out From Memory
1. Lift the handset and listen for the dial tone.
2. Press the

[AUTO] button, and then press the memory location [0 - 9].

3. The number stored in that location will be dialed automatically.

Handset Volume - Adjust the [HANDSET VOLUME] switch to the

LO/MID/HI position.

Ringer On/Off - To avoid being disturbed by the ringer during incoming

calls, slide the

[RINGER ON/OFF] switch to the OFF position.

In use Indicator - Indicator lights when the phone is in use.

Flash - Press the [FLASH] button to activate services such as call

waiting or call transfer. You must subscribe to these services from your

local phone company.

Redial - To redial the last number you called, pick up the handset and

press the

[REDIAL] button.

Hold - Press the [HOLD] button to temporarily put a caller on hold.

Press the

[HOLD] button again to continue the conversation.

Telephone Operation

11 - Store
12 - Redial
13 - Hold
14 - Flash
15. Line jack
16 - Ringer ON/OFF switch
17 - Handset volume Hi/Mid/Low control
18 - Speaker volume control
19 - Mountable wall bracket slots
20 - Mountable wall bracket

1 - Hook switch
2 - Handset
3 - Speaker
4 - Coil cord
5 - Photo frame
6 - Numeric keypad
7 - Mic
8 - In use indicator light
9 - Auto (memory dialing)
10 - HF (speakerphone)

20

16

17

18
19

15

14

13 11

12 10

9 8

7

5

5

6

5

5

4

3

2

1

MIC

HF

REDIAL

FLASH

AUTO

STORE

HOLD

Location of controls

attach the wall mount bracket
to the back of the phone

Figure 2

Installation (Cont.)

M IC

H F

R ED IAL

FLASH

AU TO

STO RE

H O LD

Photo

Clear Photo Cover

Figure 3

Inserting Photos (Figure 3).

1. Place the photo in the desired
keypad slot.
2. Cover the photo with the provided
clear photo cover.

Advertising