EAW AS422e - Manual (Page 2)

SPECIFICATIONS AS422e
DIMENSIONAL DRAWING A & E SPECIFICATIONS
One Main Street, Whitinsville, MA 01588 508 234 6158 Toll Free 800 992 5013 FAX 508 234 8251 [email protected] www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. AS422e/2 pp October 2001 Printed in USA
INDICATES MOUNTING POINT,
3/8-16 THREADED HOLE (PI ANGLE)
INDICATES MOUNTING POINT,
3/8-16 THREADED HOLE (NUT PLATE).
INDICATES CENTER OF BALANCE.
FRONT
22.50
24.62
GRILLE PARTIALLY SHOWN
BACK
4.00 (1.50)
C
5.00
L
L C
19.50
6.94
ACCESS PANEL
INPUT
509139 (0)
TOP/BOTTOM
16.31 23.00
4.24
L C
A
A
20°
11.75
19.39
(16.51)
13.64
SIDES
DIMENSION APPLY
TO BOTH SIDES
L C
4.63
16.56
18.60
The low frequency loudspeaker system shall incorporate 2x
12-in LF transducers that shall be mounted in slanted baffles
and separated vertically.
System frequency response shall vary no more than ±3 dB
from 67 to 500 Hz measured on axis. The system shall produce
a Sound Pressure Level (SPL) of 102 dB SPL on axis at 1 meter
with a power input of 1 Watt, and shall be capable of pro-
ducing a peak output of 137 dB SPL on axis at 1 meter. The
system shall handle 800 Watts of amplifier power (continu-
ous) and shall have a nominal impedance of 4 Ohms.
The loudspeaker enclosure shall be trapezoidal in shape. It
shall be constructed of multi-ply, void-free cross-grain-lami-
nated, exterior grade, Baltic birch plywood and shall employ
extensive internal bracing. It shall be finished in wear-resist-
ant textured black paint. Input connectors shall be 2-contact
terminal barrier strips. Eighteen (18) 3/8"-16 threaded
mounting/suspension points (4 each top, bottom and sides, 2
on back) shall be provided. The front of the loudspeaker shall
be covered with a powder coated perforated steel grille.
The low frequency loudspeaker shall be the EAW model
AS422e.
20°
509139 (0)
5/22/01
Manufacturing tolerances are +/- 0.13 and +/- 1°