Epson 36-075 - Manual (Page 7)

7 7 7
Use proper extension cords. Make sure your extension
cord is in good condition and is a 3-wire extension cord
which has a 3-prong grounding type plug and a 3-pole
receptacle which will accept the tool’s plug. When using
an extension cord, be sure to use one heavy enough to
carry the current of the saw. An undersized cord will
cause a drop in line voltage, resulting in loss of power
and overheating. Fig. 12, shows the correct gage to use
depending on the cord length. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier
the cord.
Fig. 12
0-6
0-6
0-6
0-6 120
120
120
120 up to 25
25-50
50-100
100-150 18 AWG
16 AWG
16 AWG
14 AWG
Ampere
Rating
Volts Total Length of
Cord in Feet
Gage of
Extension Cord
6-10
6-10
6-10
6-10 120
120
120
120 up to 25
25-50
50-100
100-150 18 AWG
16 AWG
14 AWG
12 AWG
10-12
10-12
10-12
10-12 120
120
120
120 up to 25
25-50
50-100
100-150 16 AWG
16 AWG
14 AWG
12 AWG
12-16
12-16
12-16 120
120
120 up to 25
25-50 14 AWG
12 AWG
GREATER THAN 50’ NOT RECOMMENDED
0-6
0-6
0-6
0-6
6-10
6-10
6-10
6-10
10-12
10-12
10-12
10-12
12-16
12-16
12-16
240
240
240
240
240
240
240
240
240
240
240
240
240
240
240
up to 50
50-100
100-200
200-300
up to 50
50-100
100-200
200-300
up to 50
50-100
100-200
200-300
up to 50
50-100
18 AWG
16 AWG
16 AWG
14 AWG
18 AWG
16 AWG
14 AWG
12 AWG
16 AWG
16 AWG
14 AWG
12 AWG
14 AWG
12 AWG
GREATER THAN 100’ NOT RECOMMENDED
MINIMUM GAUGE EXTENSION CORD
EXTENSION CORDS
RECOMMENDED EXTENSION CORD SIZES FOR USE
WITH STATIONARY ELECTRIC TOOLS
OPERATING INSTRUCTIONS
FOREWORD
Delta Model 36-075 is a 10" Compound Power Miter Saw designed to cut wood. Compound angle and bevel cutting are
easy and accurate. It can crosscut up to 5-3/4" x 2-3/8", miter at 45 both left and right 4-1/8" x 2-3/8", bevel at 45 left
5-7/8" x 1-9/16", and compound 45 x 45, 4-1/8" x 1-9/16". It has positive miter at 0, 22.5, and 45 degrees both left and
right, and bevel stops at 0 and 45 degrees adjustable.