Precision Flight Serial CAT II and X-Plane 8.61 - Manual (Page 4)

24. Click on SET MAX on Throt1, Throt2, Throt3, Throt4, Throt5, and Throt6.
25. Pull the levers all the way to aft position or bottom
26. Click on SET MIN on Throt1, Throt2, Throt3, Throt4, Throt5, and Throt6.
Aileron Calibration:
27. Now turn and hold your yoke all the way to the LEFT and click on Set LEFT on ROLL
28. Now turn and hold your yoke all the way to the RIGHT and click on Set RIGHT on ROLL
29. Center the yoke now and click on SET CENTER on ROLL
Elevator Calibration:
30. Pull the and hold yoke all the way out and click on SET UP on PITCH
31. Push and hold the yoke all the way in and click on SET DOWN on PITCH
32. Center the yoke now and click on SET CENTER on PITCH
Trim Calibration:
NOTE: To assure proper trims function, you will need to make sure that your trim is a separate channel. To
test, move your rudder trim while in Center tab and check if the rudder trim indicator (green shade)
moves. If it does not move, skip this and go back to Step 11 and disable the PFC Rudder Trim check box.
33. Make sure the Aileron Trim is turned all the way to the left and click on SET LEFT on AIL TRIM
34. Make sure the Aileron Trim is turned all the way to the Right and click on SET RIGHT on AIL TRIM
35. Now make sure that the Aileron Trim is Centered and click on Set Center
36. Make sure the Rudder Trim is turned all the way to the left and click on SET LEFT on RUD TRIM
37. Make sure the Rudder Trim is turned all the way to the Right and click on SET RIGHT on RUD TRIM
38. Now make sure that the Rudder Trim is Centered and click on Set Center on RUD TRIM
If you do not have Precision Flight Controls Cirrus Pedals please skip this step. Please also go back to Step 13
and Disable the PFC Serial Port Rudder Pedals.
39. Push the Right Pedal all the way to the Right and click on SET RIGHT on the RUDDER
40. Push the LEFT Pedal all the way to the Left and click on SET LEFT on the RUDDER
41. Center the PEDALS now and click on SET CENTER on RUDDER
42. We’re almost done, step on both of your brakes at the same time and click on SET MAX on the LEFT
BRAKE and RIGHT BRAKE
43. You noticed that green shade follows the movement of the brakes, I need you to step on the brakes
just until the green shade for both brake come up about 10 percent of the whole travel and click on
SET MIN
44. Click on X on the upper left hand corner.
45. Now move your mouse to the top of the screen and click on FILE and then QUIT
46. Start X-Plane again and all the controls should work now.