Primare PRE32 preamplifier - Manual (Page 6)

P r e 3 2 u s e r g u i d e

conFiguring the settings
The PRE32 includes a General settings menu that allows you to customise the
inputs to suit the sources in your system. It also allows you to configure general
aspects of the PRE32’s operation.
u s i n g t h e s e t t i n g s
m e n u
To display the settings menu
• Hold down the @ button on the front panel,
or press and hold the MENU button on the
remote control.
The settings menu is displayed:
General settings
VOL
10
Input 1
Status Enabled
To step between settings
• Turn the SELECTOR control on the front
panel, or press the A or V buttons on the
remote control.
The current setting is shown highlighted:
General settings
VOL
10
Master bal 00 LR 00
Volume default 10
Volume max 79
To change a setting
• Press the R button on the front panel, or the
SELECT button on the remote control.
The current value is shown highlighted:
General settings
VOL
10
Master bal 00 LR 00
Volume default 10
Volume max 79
• Turn the SELECTOR control on the front
panel, or press the A or V buttons on the
remote control, to change the value of the
setting.
As you change it the new value is shown in the
menu:
General settings
VOL
10
Master bal 00 LR 00
Volume default 12
Volume max 79
• Press the R button on the front panel, or
the SELECT button on the remote control
to save the value you have set.
To exit from the settings menu
• Hold down the @ button on the front panel,
or press the MENU button on the remote
control.
c u s t o m i s i n g i n P u t s
The first four items on the settings menu allow
you to customise the five inputs to suit the
sources in your system.
To select a source
Set the Input setting to the number of the input
you want to customise:
General settings
VOL
10
Input 2
Status Enabled
The following items then allow you to customise
the settings for that source:
Status can be changed to Disabled to remove
the source from the sources you can select.
Alias allows you to give a name of up to six
letters or digits to each source; see next section.
Source bal allows you to customise the balance
for the source, from 0 to -9 in either direction.
Source offset allows you the adjust the relative
volume of the source, between +10 and -10.
To give an alias to a source
• Highlight the Alias item, then press the
R button on the front panel, or press the
SELECT button on the remote control.
The alias editor is displayed:
General settings
VOL
10
5 6 7 8 9 A B C D E F
• Turn the SELECTOR control on the front
panel, or the < or > buttons on the remote
control, to select the first letter.
•
Press the R button on the front panel, or the
SELECT button on the remote control, to
select it:
General settings
VOL
10
7 8 9 A B C D E F G H
C
• Repeat for the remaining letters.
• Press the button on the front panel.
The source will be displayed with your alias:
General settings
VOL
10
Status Enabled
Alias CD
Source bal 00 LR 00