Primare A60 power amplifier - Manual (Page 8)

A60 Two-Channel Power Amplifier User Guide 
BesT soUnd
The phase of the AC supply can make a significant
difference to the sound.
Ensure that the live pin of the AC power cable is
connected to the left-hand pin of the power connector,
viewed from the back panel:
Live
BUrn-in
Your Primare will sound best after an initial burn-in of
approximately 24 hours.
You will notice a further smaller improvement in sound
quality for at least another 3 days’ playing.
rs
The RS232 input allows you to connect the A60 to a
controller system. For more information please contact
Primare or visit www.primare.net.
TriGGer inPUT/oUTPUT
The trigger input and output allow you to link your
Primare products together, using the trigger cable
supplied with each product, so they switch on or to
standby in sync with the PRE60.
To link the PRE60 to a Primare source
• Connect the trigger cable from the PRE60 TRIG OUT to
the source TRIG IN.
• If necessary, configure the source to TRIG ON.
To link the Primare source to the A60
• Connect the trigger cable from the source TRIG OUT to
the A60 TRIG IN.
To link two A60 amplifiers for bi-amping
• Connect the trigger cable from the first A60 TRIG OUT
to the second A60 TRIG IN.
AddiTionAl informATion