Primare CD22 CD player - Manual (Page 8)

C d 2 2 u s e r g u i d e

teChniCal speCifiCation
Every component of the CD22, from the CD transport to the audio output stage,
has been designed to achieve the highest possible audio performance.
f e a t u r e s
Mechanism
Asatech 8210.B01-02, Sanyo SF-P101N
D/A Converter
SRC4382 (upsampling), PCM1792A (DAC) up to
24Bit/192kHz
o u t p u t s
Analogue outputs
2VRMS, 100Ω impedance
Digital outputs
Coaxial: SPDIF (RCA)
Optical: TOSlink
Upsampling
44.1kHz, 48kHz, 96kHz, or 192kHz.
u s b p o r t
File format
MP3 or WMA
Disk format
FAT16 or FAT32
o t h e r i n p u t s
IR input: 3.5mm
RS232
Trigger in/out: 3.5mm
p e r f o r m a n C e
Frequency response:
20Hz – 20kHz (-0.5dB)
Signal to noise ratio
20Hz – 20kHz unweighted -100 dB
THD + N: 20Hz – 20kHz <0.01%
g e n e r a l
Power Consumption
Operating 25W
Idle 23W
Standby 0.3W
Size
430 x 375 x 106 mm (WxDxH)
Weight
10.5 kg
Color
Black or titanium
additional information
These instructions help you get the best possible sound from your CD22, and give
information about configuring its advanced settings.
p h a s e
The phase of the AC supply can make a significant
difference to the sound.
Ensure that the live pin of the AC power cable
is connected to the left-hand pin of the power
connector, viewed from the back panel:
Live
b u r n - i n
Your Primare will start to sound best after an
initial burn-in of approximately 24 hours.
You will notice a further smaller improvement in
sound quality for at least another 3 days’ playing.
r s 2  2 a n d t r i g g e r s
The RS232 input allows you to connect the CD22
to a controller system. For more information
please contact Primare or visit www.primare.net.
The Trigger input allows the CD22 to be switched
on by another device, such as an I32.
The Trigger output allows the CD22 to switch on
other devices.
u s i n g t h e g e n e r a l
s e t t i n g s m e n u
To display the General Settings menu
• Press and hold down the O button until the
display shows the version number:
V1-00
NOTE: You need to keep the O button held
down throughout this procedure.
To set the IR input
• Press the */å button until the display shows:
IR
• Press the >/] button to select between
IR FRONT, to control the CD22 using a
remote control pointed at the front panel, or
IR BACK, to control it via the IR input on the
back panel.
To set the trigger input
• Press the */å button until the display shows:
TRIG
• Press the >/] button to select between
TRIG ON, to enable the trigger input, or
TRIG OFF, to disable it.
• Release the O button to return to normal
operation.