Electrolux EDE 57160W - Manual (Page 12)

12 electrolux use
Select the Start/Pause
Press this button to start the dryer after
having selected the programme and
the options. The relevant light will stop
flashing. If the door of the appliance or
the small door at the bottom is opened
while the programme is running, this
button must be pressed again after
closing the door in order to restart the
programme from the point at which it
was interrupted. In both cases the light
of the Start/Pause button flashes to
remind you that the start button needs
to be pressed again.
IIn nd diic ca atto orr lliig gh htts s
These lights indicate the following
functions:
““D Drry yiin ng g”” lliig gh htt
This light indicates that the appliance is
in the drying phase.
““C
Co oo olliin ng g”” lliig gh htt
This light indicates that the appliance is
in the cooling phase. At the end of
drying, there is a 10 minute cooling
phase to cool the laundry.
““E
En nd d o off p prro og grra am mm me e”” lliig gh htt
This light is on at the end of the cooling
phase, during the anti-creasing phase
and at the end of the programme.
““F
Fiilltte err c clle ea an niin ng g”” lliig gh htt
It comes on every 80 cycles to remind
you that the condenser must be
cleaned.
E.27
At the end of the programme
All drying programmes end with a 10
minute cooling phase.
If the laundry is not removed at the end
of the cycle, the dryer performs an
anti-creasing phase (duration: 30 min-
utes maximum).
If you do not remove the laundry, the
dryer will stop automatically at the end
of the anti-creasing phase.
Lights end and filter remain lit and the
buzzer sounds for 2 minutes.
Turn the programme selector dial to “0”;
all the lights go out. The appliance is
switched off.
Remove the laundry.
If you open and then close the door
before turning the selector dial to “0” all
the indicator lights come on.
A Afftte err e ea ac ch h u us se e
• Clean the filters.
Important!
If the drying programme has to be
stopped before it reaches the end, we
recommend that you turn the pro-
gramme selector dial to position Cooling
and wait until the end of this cooling
phase before removing the laundry. This
will avoid a build-up of heat inside the
appliance.To do this first turn the dial to
“O O” and then to Cooling and depress
the Start button.
M Mo od diiffy yiin ng g tth he e p prro og grra am mm me e
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to “O
O”. Select the
new programme and press the Start
button .
125986421_gb.qxp 2007-10-05 07:50 Page 12