RISCO Group ProSYS B23UL - Manual (Page 2)

2
Mounting the Attack Enclosure
To mount the attack enclosure, follow this procedure:
1. Remove all the metal knockouts from the cabinet.
2. Plug unused knockout holes with a pair of disc plugs, bolts and nuts as described in
Figure 2 A+B.
Bigger knockouts may be used for wire transfer.
Pay attention: There are 2 sizes of knockout holes.
3. Mounting the cabinet lock:
i Insert the key in to the lock.
i
Position the lock in the designated hole, making certain that the latch will make
contact with the latch bracket when the door is closed.
i When positioned, push the lock until it is secured by its snap tabs.
4. After all wiring, accessories assembly and programming checkout have been
completed, fasten the cabinet door to the cabinet itself using the supplied screws
(Fig.3).
Fig.1 ProSYS box