RISCO Group WL Internal Round Sounder - Manual (Page 7)

Wireless Sounder Instructions 7
Adjusting the Volume
Defines the sounder sound volume for the following system modes
¾ Exit / Entry: The sound produced during Exit/Entry time (Default: 0)
¾ Alarm: The sound produced during alarm (Default: 9)
¾ Squawk: The sound produced during squawk sounds (Default: 9)
The sound volume range is between 0 (silent) to 5 (maximum volume).
Muting Tamper
This feature disables a tamper alarm from the sounder and it is recommended to be
used when replacing sounder's batteries.
NOTES:
1. An ongoing tamper alarm will not be disabled.
2. WisDom: This feature is controlled under the Engineer Menu (Quick key [9][2][5]). Tamper alarm
will be disabled during the current installation programming period.
3. Agility: This feature is controlled under the Grand Master menu. Tamper alarm will be disabled for
20 minutes.
Setting Supervision Time
Specifies how often the system generates a supervision request to the sounder.
If any of the sounders does not respond to the request at least once, during the
receiver supervision time, the system will regard the accessory as lost.
NOTE:
The receiver supervision time should be higher than the sounder supervision time in order to
eliminate false lost event.
Range: 00-255 minutes
Default: 58 minutes
NOTE:
WisDom: Engineer menu: 1) System > 1) Timers > 9) Accessory supervision time
Agility: Engineer menu: 1) System > 1) Timers > TX supervision
Pre Alarm indication
This wireless sounder incorporates a pre - alarm feature that enhances the security of
the system, by producing a local alarm in case of sabotage.
If defined, the system sends a pre-alarm signal to the sounder at the beginning of the
entry delay. If the sounder does not receive a cancellation signal from the system at
the end of the entry time, the sounder goes into alarm mode.
NOTE:
WisDom (Ver 4.25): Engineer menu Quick key 1) System > 2)Controls > 44) Pre alarm
Agility: Engineer menu [1][2] > Advanced > Sounder Pre alarm