Electrolux EWF 12040 - Manual (Page 14)

14 electrolux use
Interrupting a programme
Depress the “Start/Pause” button to
interrupt a programme which is running,
the corresponding light starts to flash.
Depress the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to “O” to cancel
a programme which is running. Now
you can select a new programme.
Opening the door after the
programme has started
First set the machine to pause by
pressing the “Start/Pause” button.
If the “door”
light flashes and after
3 minutes goes off, the door can be
opened.
If the “door”
light does not switch
off, this means that the machine is
already heating, that the water level is
above the bottom edge of the door or
that the drum is turning.
In this case the door can not be
opened.
If you cannot open the door but you
need to open it you have to switch the
machine off by turning the selector dial
to “O”. After about 3 minutes the door
can be opened (pay attention to the
water level and temperature!).
At the end of the programme
The machine stops automatically.
If the Rinse Hold or Night Cycle
option has been selected, the
phase lights “end” and “door”
illuminate, the “Start/Pause” light
goes off and the door remains locked
to indicate that the water must be
emptied out before opening the door.
To empty out the water please read
the steps on the Rinse Hold option
paragraph.
Turn the programme selector dial to
“O” to switch the machine off. Remove
the laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out
another wash, close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant
smells.
132980570_EN.qxd 30/06/2006 15:12 Pagina 14