Rose Electronics RackView LCD Monitor - Manual (Page 6)

Page 6 Rackview LCD Monitor WWW.ROSE.COM
Pre-Installation and Package Contents
Before Installation:
It is very important to mount the equipment in a suitable cabinet or on a stable surface.
Make sure the mounting location has good ventilation, is out of direct sunlight, and away from sources of
excessive dust, dirt, heat, water, moisture and vibration.
Unpacking:
The equipment comes with the standard parts shown in package content. Check and make sure they are
included and in good condition. If anything is missing, or damaged, contact your supplier immediately.
Package Contents:
1x Rackview LCD Unit
1x set of Mounting Bracket (sliding rails)
1x Power Cord
1x VGA Cable
1x User Manual
1x set of screws and washers for assembly
Product Operation:
a) Power On Procedure
• Power on the Rackview LCD Monitor (see power switch on back panel)
• Power on the CPU
b) Video Input Select Button (see OSD Section, Page 12)
The Rackview remembers the last valid video input selection, so if the CPU input has changed, the user needs
to re-select the video input.
• Locate the “Video Input Select” button on the OSD display control panel
• Push the Video Input Select button to toggle between VGA and DVI Input
• Select the appropriate Video Input format (VGA or DVI)
c) Cleaning Your Monitor
To clean your LCD safely, please follow these steps:
• Disconnect the power cord.
• Gently wipe the surface using a clean, dry microfiber cloth. Use as little pressure as possible.
• Use only screen cleaning products designed for use with LCD monitors.