Rose Electronics Remote Control Panel - Manual (Page 4)

INTRODUCTION
Disclaimer
While every precaution has been taken in the preparation of this manual, the
manufacturer assumes no responsibility for errors or omissions. Neither
does the manufacturer assume any liability for damages resulting from the
use of the information contained herein. The manufacturer reserves the right
to change the specifications, functions, or circuitry of the product without
notice.
The manufacturer cannot accept liability for damages due to misuse of the
product or other circumstances outside the manufacturer’s control. The
manufacturer will not be responsible for any loss, damage, or injury arising
directly or indirectly from the use of this product.
System introduction
Thank you for choosing the Rose Electronics

Remote Control Panel
 for
your remote KVM switching application. The Remote Control Panel is the
results of Rose Electronics commitment to provide solid, practical switching
solutions for today's business world. The Remote Control Panel connects
directly to the RS232 serial port on a KVM switch allowing you to remotely
switch to any CPU port.
The Remote Control Panel is easy to install and operate. No set-up is
required; just connect a Rose Electronics UltraView, ServeView, or
MultiVideo product to the Remote Control Panel with an RJ11 cable, apply
power and push the button. If you push button #5 on the Remote Control
Panel, the CPU connected to port 5 on the KVM switch will connect to the
KVM port and display on the KVM station.