Sandia 2-Gallon Spot Extractor - Manual (Page 5)

(8) 2-Gallon Spot Extractor
5.0 Wiring Diagram
CAUTION – Electrical wire colors may vary. Determine start and end point of
each wire to confirm connection point.
2-Gallon Spot Extractor (5)
Returned Material Authorization (RMA) Procedure
The original purchaser must contact the manufacturer to follow correct RMA/warranty
procedures. A copy of the RMA Sheet but be included and enclosed in the box with
returned item. No returns shall be authorized unless the proper RMA procedures are
followed. It is the responsibility of the distributor to repair the customer’s equipment as
soon as possible. If the distributor does not have the facilities to repair the equipment, it
may be shipped or taken to an authorized service center for repair.
The customer must contact the manufacturer prior to working on or changing out any
parts, etc. The manufacturer must issue an RMA Sheet containing approved labor time
and replacement parts. Do not send parts or equipment back to manufacturer without
an RMA Number and approval. No labor will be paid for, nor part costs paid for or
reimbursed that have not been previously approved by manufacture. All warranty work
must be approved and authorized to qualify and appropriate warranty procedures must be
followed.
1.0 Safety Instructions
WARNING: PLEASE READ AND SAVE! FOLLOW THESE PRECAUTIONS
WHEN USING YOUR SPOT EXTRACTOR.
• DO NOT operate this unit if any part of the unit appears to be damaged.
• DO NOT operate if ground plug is broken.
• DO NOT operate if the unit is in standing water.
• DO NOT use volatile substances or operate where volatile substances exist.
• DO NOT service while unit is running or connected to electricity. Unplug the unit!
• DO NOT use water more than 120 degrees Fahrenheit.
• DO NOT use solvents with this unit.
• DO NOT use as a dry vacuum.
• DO NOT use unit unless completely assembled.
• Use only liquid detergents. Powders do not fully dissolve and damage motor.
• Always us defoamer. Foam will suspend moisture particles that damage motor.
2.0 Set-Up / Prepare Unit for Use
DO NOT EXPOSE TO RAIN. STORE INDOORS.
• All spot extractors – no matter what the time of year – are shipped with antifreeze
in the pump and solution lines. Prior to first use, fill the tank with one quart of warm
water. Attach the hose and using the hand tool, flush out the system by spraying the
one quart of water through the pump.
• Attach the 1-1/2 inch vacuum hose and the brass quick disconnect.
• Fill the base unit (the recovery tank must be removed) with warm water (less than
100 degrees Fahrenheit). Fill to approximately 4 inches from the top. Use a liquid
detergent made for carpet cleaning or upholstery. Read and mix to the dilution ratios
as directed.