Electrolux 75011 VIL - Manual (Page 25)

Programme Degree of
soil
Type of
load
Programme description Consumption val-
ues 1)
Pr
ew
ash
Ma
in wa
sh
Intermedi
ate ri
nse
Final rinse Drying Duration (
m
inutes)
Ene
rgy (kWh)
Water (l
itres)
Any Partial load
(to be com-
pleted later
in the day)
5)
12
0,1
4
1) The consumption values are intended as a guide and depends on the pressure and the temperature of the water
and also by the variations of the power supply and the amount of dishes.
2) During the Auto washing programme the amount of soil on the dishes is determined by how cloudy the water
is. The programme duration, water and energy consumption levels can vary; this depends upon if the appliance
is fully or partially loaded and if the dishes are lightly or heavily soiled. The temperature of the water is
automatically adjusted between 45° C and 70° C.
3) Ideal for washing a partially loaded dishwasher. This is the perfect daily programme, made to meet the needs
of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery.
4) Test programme for test institutes.
5) This programme does not require the use of detergent
Select and start a washing programme
Select the washing programme and delay start with the door slightly opened.
The start of the programme or the countdown of the delay start will occur
only after the closure of the door. Until then it is possible to modify the
settings.
1. Check that the baskets have been loaded correctly and that the spray arms are
free to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher must be in setting mode.
4. Press the button corresponding to the required programme (see "Washing
programmes" chart). Close the dishwasher door, the programme starts
automatically.
Select and start a washing programme 25