Electrolux 1600 - Manual (Page 58)

58
Installation on a Suspended Floor
Suspended wooden floors are particularly susceptible to vibration. To
help prevent vibration we recommend you place a waterproof wood
panel, at least 15mm thick under the appliance, secured to at least
2 floor beams with screws. If possible install the appliance in one of the
corners of the room, where the floor is more stable.
Levelling the appliance
3
Self adjusting foot: The rear foot of your washing machine is designed
like a spring leg. This makes the machine very stable even at high spin
speeds.
If the washing machine is still not stable during spinning, proceed as
follows:
1. Set the three adjustable feet to
the nominal value of 10mm. Use
the supplied spanner.
If the self adjusting foot does not
reach the floor:
2. Manually extend the self
adjusting foot (rear left) to the
required length.
3. Check the appliance is level using
a spirit level.
Important! Never use strips or
shims of wood or cardboard etc.
to compensate for any unevenness in the floor. Always use the adjusta-
ble feet.