Maintenance and cleaning, Descaling, After each wash – Electrolux WM 1200 A User Manual

Page 16: External cleaning, Cleaning the dispenser drawer, Cleaning the drawer recess, Cleaning the filter

Advertising
background image

16

Maintenance and Cleaning

Before any maintenance or cleaning is carried out you
must DISCONNECT the appliance from the electricity
supply.

Descaling

The water we use normally contains lime. It is a good
idea to periodically use a water softening powder in the
machine. Do this separately from any laundry washing,
and according to the softening powder manufacturer's
instructions. This will help to prevent the formation of
lime deposits.

After each wash

Leave the door open for a while. This helps to prevent
mould and stagnant smells forming inside the appliance.
Keeping the door open after a wash will also help to
preserve the door seal.

External cleaning

Clean the exterior cabinet of the appliance with soap
and water only, and then dry thoroughly.

Cleaning the dispenser drawer

From time to time the washing powder and additive
dispenser drawer should be cleaned.
Remove the drawer by pressing the catch downwards
and by pulling it out. Flush it out under a tap, to remove
any traces of accumulated powder.

P0878

P0879

Cleaning the drawer recess

Having removed the drawer, use a small brush to clean
the recess, ensuring that all washing powder residue is
removed from the upper and lower part of the recess.
Replace the drawer and run the rinse programme
without any clothes in the drum.

Cleaning the filter

The water drain filter

A clean filter is important for the correct functioning of
the machine, and should therefore be cleaned after every
washing programme.

Open the filter door and place a container underneath to
catch any spillage.

If the filter is blocked and the machine is unable to drain
you will need to drain the water manually from the
machine at this stage. To do this, unhook the drain hose
from the standpipe or sink and hold the end of the hose
over a bowl on the floor. The water should drain by
gravity into the bowl. When the bowl is full, hook the
hose back up and empty the bowl. Repeat the procedure
until water stops flowing out.

Unscrew and remove the filter.

P0133

P0132

P0011

P0038

Advertising
This manual is related to the following products: