Fulton Performance 44314R0303 - Manual (Page 2)

DESCRIPTION QTY.
COUPLERS
(1)
1
PART # REPAIR KIT KIT DESCRIPTION ITEM
02 251 37
3 02 410 12 SPRING - COMPRESSION
COUPLER WELDMENT
02 380 02 LINK PIN
2
4
LOCKING LEVER ASSEMBLY 02 702 08
(1)
(1)
(1)
02 270 57 6 GROOVE PIN (1)
02 700 18 5 BALL CLAMP (1)
44305R BALL CLAMP
REPAIR KIT
64 0801
PARTS BREAKDOWN
TO UNLATCH COUPLER FROM HITCH BALL:
1)
2) Fully open locking lever. While holding locking lever fully open, raise coupler off of hitchball (See
figure 1). NOTE: An optional hold open pin can be used.
3) Return handle to closed position.
Before unlatching coupler, make sure vehicle, trailer and load will not shift, roll, etc. NOTE: Load
may have shifted during transit, resulting in a negative tongue load. Use caution when unlatching
coupler, as tongue may rise unexpectedly when unlatched. If lock or pin is in lever, remove it before
removing coupler from hitch ball.
TO LATCH COUPLER TO HITCH BALL:
1) Before latching coupler, make sure vehicle, trailer and load will not shift, roll, etc.
2) Open coupler locking lever (See Figure 1). While holding locking lever open, lower the coupler over the hitch ball until
ball is fully seated into the ball pocket of the coupler (See Figure 2). NOTE: The locking lever will close due to internal
spring and therefore must be held open or pinned open.
3) If locking lever is pinned open, remove pin. Close locking lever to the closed position (See Figure 3). DO NOT force
handle down. If handle does not close easily, trailer and tow vehicle may be misaligned. Re-align as necessary. Check that
latch is engaged by lifting up on back of locking lever (See Figure 4). Also, check that the hitch ball is fully seated and ball
clamp is below the ball (See Figure 5). If the ball is not seated WITH lever in the closed position, DO NOT TOW. Repeat
the above steps.
4) OPTIONAL: Place a pin or lock in hole shown (See Figure 5). A lock can be used in place of the pin as a theft deterrent.
OPERATING INSTRUCTIONS
N/A
N/A
FIGURE 1
LOCKING LEVER
FULLY OPEN
FIGURE 2
HITCHBALL SEATED
FIGURE 3
BALL SEATED WITH
LEVER CLOSED
LOCKING LEVER
OPTIONAL
HOLD OPEN
PIN
LOCATION
LATCH
OK
TO
TOW
FIGURE 5
BALL CLAMP
BELOW BALL
LATCH
ENGAGED
LIFT HERE WITH FINGER TO
ENSURE LATCH IS ENGAGED
FIGURE 4
ENSURE LATCH IS
ENGAGED
OPTIONAL
PIN LOCATION
BALL NOT SEATED!!!
DO NOT TOW!!!
LEVER NOT CLOSED!!!
DO NOT TOW!!!
LEVER NOT CLOSED!!!
LATCH NOT ENGAGED!!!
DO NOT TOW!!!
PART #
02 251 06
02 410 12
02 380 02
02 702 08
02 270 57
02 700 18
44305R 44314R
1050 Indianhead Dr., P.O. Box 8 Mosinee, WI 54455-0008
800/604-9466 715/693-1700 Fax 715/693-1799
www.fultonperformance.com
[email protected]
F3190 (RE-8791) 6/03