KEPCO BHK-MG VISA Driver Manual (Both Full and 1/2 Rack) - Manual (Page 4)

4
BHK-MG-VISA 010906
Set Trigger Voltage and
Current KpBhk_SetTrig_Volt_Curr Sets the trigger voltage and trigger current at the same time
Set Trigger Value KpBhk_SetTrigValue Sets the trigger voltage or trigger current level, depending on the switch
position.
Get Trigger Value KpBhk_GetTrigValue Gets the trigger voltage or the trigger current level, depending on the
switch position.
Set Overvoltage and
Overcurrent KpBhk_Set_OVvolt_OVcurr Sets both the overvoltage and overcurrent values.
Set Protection Delay KpBhk_setProtDelay Sets the protection delay: the delay between the moment the output
voltage and current are changed and the moment the overvoltage and
overcurrent protections are enabled.
Get Protection Delay KpBhk_getProtDelay Displays the protection delay count for the power supply. A count of 30
represent ~ 1 second. The protection delay is the delay between the
moment the output voltage and current are changed and the moment
the overvoltage and overcurrent protections are enabled.
ACTION/STATUS FUNCTIONS — This class of functions executes commands and queries. It also provides functions which allow
the user to determine the current status of the instrument.
Set Voltage and Current KpBhk_Set_Volt_Curr Sets the output voltage and current at the same time.
Set Value KpBhk_SetValue Sets the output voltage, the output current, the overvoltage level, or the
overcurrent level of the power supply, depending on the slide selection
position. The values are checked against the maximum acceptable val-
ues for the corresponding power supply.
Get Value KpBhk_GetValue Gets the output voltage, the output current, the overvoltage level, or the
overcurrent level of the power supply depending on slide selection
position.
Trigger KpBhk_Trig Triggers the instrument once. The output will go to the trigger voltage
and current values.
Measure Output Value KpBhk_MeasValue Measures the value of output voltage or current depending on the
switch position.
Get Source Mode KpBhk_GetSourceMode Gets the operating mode of the power supply.
Output On/Off KpBhk_OutputOnOff Sets the output on or off.
Get Output Status KpBhk_getOutputState Returns the output status (on or off).
Get Current Range KpBhk_getCurrRange Gets the operating current range of the power supply.
Set Current Range KpBhk_setCurrRange Sets the operating current range of the power supply
Abort Measurement KpBhk_abortMeas Sends the abort command.
Beep KpBhk_beep The selected BHK-MG power supply will emit a beep.
DATA FUNCTIONS — This class of functions transfers data to or from the instrument.
Questionable Data KpBhk_StatQues Tests for questionable data, then gets the condition.
Run/Stop LIST Program KpBhk_Prog Sends a RUN or STOP LIST program command.
Get Status of LIST Pro-
gram KpBhk_Prog_Stat Gets status of program: 0 = stopped, 1 = running
Send Direction of LIST
Program KpBhk_Prog_Dir Sends direction to run LIST program (UP or DOWN). Does NOT apply
to 40-step LIST programs available from front panel.
Send Loop Count of
LIST Program KpBhk_Prog_Count Sends loop count value - how many times the LIST program will run.
Value of 0 = run continuous. Does NOT apply to 40-step LIST pro-
grams available from front panel.
TABLE 1. BHK-MG VISA DRIVER FUNCTIONS (CONTINUED)
Purpose Function Name Description