Extron electronic HSA 402 - Manual (Page 22)

HSA 400/402 Series • Reference Information HSA 400/402 Series • Reference Information
Reference Information, cont’d
Top Plate Dimensions
The preferred and recommended method for cutting the table is
to use the correct size metal routing template (figure A-3 and
chapter 2, “Installation”) and a router. The templates are
available at no cost, see the part numbers for the templates on
page A-5.
USER ACCESS
EXTRON ELECTRONICS
USER ACCESS
Figure A-3 — HSA metal routing template
If you choose not to use Extron’s metal routing template, the
cut-out templates (figure A-4, figure A-5, figure A-6, and
figure A-7) on the following pages will help you properly
prepare the mounting surface. The cutout templates are not to
scale
and are for reference only. The surface cut-out area
dimensions on all templates are C and D and marked in bold
type
.
For full size paper templates, visit the Extron Web site
(http://www.extron.com) or call the Extron S
3 Sales & Technical
Support Hotline.
A-6 A-7
4.475" (11.37 cm)
6.425" (16.32 cm)
C = 8.113 0.0325"
(20.61 0.083 cm)
D = 5.925 0.0325"
(15.05 0.083 cm)
8.613"
(21.88 cm)
Cut surface material
out along this line. Cut-Out Radius:
0.25" (0.6 cm)
Tilting Plate Top Panel
Cut-Out Template for Extron's HSA 400
TEMPLATE IS NOT FULL SIZE.
SURFACE CUT-OUT
AREA = 8.113 0.0325"
(20.61 0.083 cm) x
5.925 0.0325"
(15.05 0.083 cm)
User Access (Connectors and AAP Openings)
US Model
6.663"
(16.92 cm)
+
+
+
+
+
+
+
+
G
H
Figure A-4 — HSA 400 US/domestic cut-out template