Extron electronic HSA 402 - Manual (Page 12)

HSA 400/402 Series • Installation HSA 400/402 Series • Installation
Installation, cont’d
2-10
HSA 402
H. SHIFT
COMPUTER INPUT
SELECT
AUDIO
RGB 580 xi SI AAP
120-240 50/60 Hz 5A 120-240 50/60 Hz 5A
3 1A 1B 1C 2 1D
Underside View
Front Panel View
1A 1B 1C 1D
Figure 2-7 — HSA 402 enclosure underside features
1 RJ-45 connectors — See “Cabling the RJ-45 connectors” on
page 2-11.
All RJ-45 connectors are teminated in accordance with
the TIA/EIA 568 A standard.
2 AC power connector — Connect this power cord to the power
source.
For US-domestic versions, this power cord is
permanently connected to the HSA.
Connect the power cord to a 125VAC, 60 Hz,
10A power source.
For international versions, this power cord is
a removable IEC power cord. Connect the
power cord to a 220-250V, 50/60 Hz, 10A
power source.
The Universal AC outlet is fully compatible with
Europlug, British, Indian, Danish, and Italian plug
types. See the universal AC outlet guide on the Extron
Web site,
www.extron.com , for compatibility details on
all plug types.
3 Cable access holes
Cabling the RJ-45 connectors
Plug one end of a twisted pair (TP) cable into each of these RJ-45
female connectors on the underside of the HSA (figure 2-6 on
page 2-9 and figure 2-7 on page 2-10). Connect the other end to
an appropriate telecommunications or data network or to an
Extron TP product.
An RJ-11 plug can be connected to the RJ-45 jack.
When cabling the front panel and the underside of the
enclosure, the bottom RJ-45 connections match up with the front
panel RJ-45 connector locations identified on figure 2-6 and
figure 2-7. For example, match the front panel RJ-45 (CAT 5/6)
network, data, or communications connection
1A with the
underside RJ-45 connector 1A , match 1B with 1B , and so forth.
Only connectors 1A and 1B are present on the HSA 400.
If necessary, on the front panel, have a qualified service person
replace the connector icon by prying the old icon off of the
connector plug-in with an Extron Tweeker or small screwdriver
(figure 2-8) and snapping a new icon in place.
Icon Label
Figure 2-8 — Changing the connector icon
2-11