Emerson SB816 - Manual (Page 8)

7
REMOVING THE “TRY ME” BATTERY PACK
Before using, an adult must remove the enclosed
“Try Me” battery pack as it is not needed in daily use.
Dispose of the button batteries in accordance with
local regulations, then install a 9V battery as
described below.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH THE
WIDE BLADE OF THE PLUG TO THE WIDE SLOT
AND FULLY INSERT.
Unravel the AC cord and connect it to a conveniently
located AC outlet having 120V and 60Hz only. The
Clock Display will illuminate and “12:00” will blink in
the window.
NOTE: If the AC plug does not fit into a nonpolarized outlet, do not file or cut the wide
blade.
If the AC cord is disconnected or if there is a power failure, this electronic clock is
designed to continue operating internally (without showing the time on the Clock Display)
with a 9 volt battery (not included). To install the battery, remove the battery compartment
cover by pressing in on the tab, then connect the battery to the terminals of the battery
snap inside the compartment (use of an alkaline battery is
recommended). Replace the battery compartment cover.
Be sure to check the condition of the battery periodically by
disconnecting the AC cord and connecting it again 2 or 3
minutes later. The preset times should continue operating. If
the present time does not appear, it indicates the battery is
dead or not connected properly.
PREPARATION FOR USE
AC Plug
AC Outlet
'8
LOCATION OF
“TRY ME”
BATTERY PACK