Installation and operation, cont’d – Extron electronic Digital Video Transmitter and Receiver HDMI 201 Tx/Rx User Manual
Page 18
HDMI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-20
HDMI 201 Tx/Rx • Installation and Operation
2-21
HDMI 201 A D Rx Front Panel
OUTPUT
Rx
Tx
RS-232
PASS THRU
AUDIO-R
HDMI
AUDIO-L
10
12
9
Figure 2-17 — HDMI 201 A D Rx front panel
connectors
g
DC power input connector — Plug the included external
12 VDC power supply into either this 2-pole connector or the
power input connector on the transmitter (item
See "Power supply wiring," on page 2-25, to wire the connector.
h
Receiver input connector — Connect one end of the two
separate TP cables from the transmitter output connectors (item
on page 2-17) to these RJ-45 female connectors.
C
Do not connect these devices to a computer data or
telecommunications network.
N
Connect transmitter output 1 to receiver input 1.
Connect transmitter output 2 to receiver input 2.
N
If necessary, test for proper cable connection (output 1 to
input 1, output 2 to input 2) as follows:
1. Plug both TP cables into the powered unit.
2. Momentarily connect either of the cables on the
opposite end into the unpowered unit‘s “2” connector.
If the unpowered unit’s Power LED is lit, the
connection is correct.
If the unpowered unit’s Power LED is not lit,
unplug the connector on the unpowered end and
connect the other cable to the “2” connector.
See "TP cable termination," on page 2-22, to properly wire the
RJ-45 connectors.
i
HDMI Output connector — Connect a display with an HDMI
input for display of the transmitted direct digital image. See
"HDMI connector pin assignments," on the next page, for pin
assignments.
j
RS-232 connector —
Connect a serial communications port to
this 3.5 mm, 3-pole captive screw connector for bidirectional
RS-232 communication. See "RS-232 connector wiring," on
page 2-26, to wire the connector.
N
The RS-232 connector can also transmit one-way
modulated infrared (IR) signals. See "Modulated IR
k
Audio Input connector (HDMI 201 A D Rx [Decora] only) —
Connect one end of a 5-wire audio cable to this 3.5 mm, 5-pole
direct insertion connector.
Connect the free end of the same cable to any compatibly
wired audio source unit, such as a switcher's output or a
HDMI 201 A D Tx (Decora) transmitter.
Figure 2-18 shows how to wire the captive screw audio
connector. Insert the wires into the appropriate openings in the
direct insertion connector. Tighten the screws on the side to
fasten the wires.
Tip
Sleeve
Sleeve
Tip
Unbalanced Input
Balanced Input
Do not tin the wires!
Sleeve (s)
Tip
Tip
Ring
Ring
L
A
U
DI
O
OUTPUT
R
L
A
U
DI
O
OUTPUT
R
Figure 2-18 — Captive screw connector wiring for
receiver audio output