Purdy AND4RRA - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] 2-21-05
www.purdyelectronics.com
AND4RRA
Ultra Bright LED Lamps
Unit: mm
AND4RRA
InGaAIP High Brightness Red Chip LED with
Right Angle Lens on Surface Mount Package
Features
• 3.0 x 1.0 x 2.0 mm right angle SMD package
• All plastic mold type, clear colorless lens
• Peak wavelength (
λ
p=632nm) high bright emission
• Low drive current: 1 to 20 mA
• Compatible with automatic placement equipment
• Compatible with infrared & vapor phase reflow solder process
• High efficiency
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F
25 mA
Pulse Voltage Current
(Duty Cycle: 1/10 @ 1KHz)
I
FP
100 mA
Operating Temperature T
Opr
-40 ~ +85 °C
Storage Temperature T
Stg
-40 ~ +90 °C
Electrostatic Discharge ESD 2000 V
Soldering Temperature T
Sol
260 ±5 (<5 seconds) °C
Power Dissipation P
d
60 mW
Reverse Voltage V
R
5 V
1. Recommended solder condition:
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA – 2.0 2.4 V
Reverse Current I
R
V
R
= 5 V – – 10 µA
Luminous Intensity I
V
I
F
= 20 mA 90 139 – mcd
Peak Emission Wavelength
λ
P
I
F
= 20 mA – 632 – nm
Spectral Line Half Width
λ
d
I
F
= 20 mA – 624 – nm
Dominant Wavelength λ /2 I
F
= 20 mA – 20 – nm
Full Viewing Angle θ IV = 1/2 peak – 120 – degree
Product specifications contained
herein may be changed without
prior notice. It is therefore
advisable to contact Purdy
Electronics before proceeding
with the design of equipment
incorporating this product.
• RoHS Compliant