EnGenius Technologies ESR-9710 - Manual

Quick Start Guide Wireless N Gigabit Router
Quick Start Guide v.1.0 ESR-9710 Wireless N Gigabit Router 1
The Wireless-N Gigabit Router is a draft 802.11n compliant device that
delivers up to 6x faster speeds than 802.11g while staying backward
compatible with 802.11g and 802.11b devices.
It is not only a Wireless Access Point, which lets you connect to the
network without wires. There's also a built-in 4-port full-duplex
10/100/1000 Gigabit Switch to connect your wired-Ethernet devices
together. The Router function ties it all together and lets your whole
network share a high-speed cable or DSL Internet connection.
This Quick Start Guide will guide you through the steps of setting up the device using the Wizards. For
advanced configuration, refer to the User’s Manual in the CD-ROM provided.
Step Label Description
1 LAN Ports (1 – 4) Use an Ethernet cable to connect each port to a computer on your
Local Area Network (LAN).
2 WAN Port Use an Ethernet cable to connect this port to your WAN router.
3 DC Connector Use the power cable and connect the adapter to the power socket
on the wall, and the DC inlet into the DC connector.
4 Antenna Connector Connect the three antennas to the SMA connectors.
Connection / Activity
LED This LED will light up once an Ethernet cable is connected to one
of the LAN ports.
WAN LED This LED will light up once an Ethernet cable is connected to WAN
(Internet) port.
WLAN LED This LED will light up once the RF (wireless LAN) feature is
enabled
Power LED This LED will light up once the power cable is connected to the DC
connector.
Reset Button Use this button to reset the device. You can restore the device
back to its factory default settings by holding down on this button
for 5 seconds.
WPS WPS (Wireless Push Button) is used for WiFi Protected Setup. By
pressing this button, the security settings of the device will
automatically synchronize with other wireless devices on your