Whelen SAK20 User Manual

Automotive: sirens & switches, Caution

Advertising

Page 1

Installation Guide:

SA315 Siren Speaker Bracket

2004-2012 Ford Escape

ENGINEERING COMPANY INC.

Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]

For warranty information regarding this product, visit www.whelen.com/warranty

51 Winthrop Road,

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-4078

Automotive:

Sirens & Switches

Protrusion on frame

Mount

bracket

flush

with

frame

here.

Hole in
bracket

1/4 X 1" Self-Drilling Hex Washer Screw HD

(Qty 5)

Slip the bracket (with siren attached) onto the frame. The square hole in the
top of the bracket will fit over the protrusion in the frame.

frame

side view

Front Bumper Assembly

Trim some plastic off of front bumper
assembly to fit siren.

Fig. 1

Fig. 2

Fig. 3

Installation:

1. Mount speaker to bracket (see next page).
2. Remove the one piece front bumper assembly from the vehicle

(Fig. 1). Refer to the vehicle factory manual for the removal
procedure.

3. Slip the bracket (with siren) onto the center of the lower frame of

the vehicle. There is a square hole in the top of the bracket that
fits over a small protrusion on the top of the frame (Fig. 2).

4. Secure the bracket to the frame with the supplied self tapping

screws. You will need a drill equipped with a 3/8” socket to drive
the screws in. Do not over tighten.

5. Replace the front bumper assembly. You will have to trim some

plastic off of the bumper assembly to make the siren fit properly.

6. Extend the WHITE (positive) and BLACK (negative) speaker

wires to your
siren amplifier
and connect as
shown in the
amplifiers
instructions.

CAUTION

Loud siren noise can cause
hearing damage and/or loss.

Refer to OSHA Section 1910.95 prior
to putting ANY siren into service!

Wear

Protection!

ACTIVATION OF THIS

SIREN MAY DAMAGE

UNPROTECTED EARS!