Electrolux EH GL5X-4 - Manual (Page 22)

Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
INSTALLATION
Warning! Refer to "Safety information"
chapter.
Installing the oven under a work surface
Warning! Installation into flammable
material must agree with NIN 2005,
chapter 4.2.2 of the VKF (Association
of Cantonal Fire Insurers) fire protection
guidelines and regulations.
1. Install the hob according to the installa-
tion instruction number 374307900/
374307901.
2. Before insert the cooker into cabinet's re-
cess make sure to carry out the hotplate
socket and use the correct socket con-
nections. There is no need to use a sep-
arate earthing.
3. Pull the appliance drawer out as far as it
goes, take hold of it and remove it.
4. Use the side handles to hold the oven
and slide it flush into the recess.
5. Use at least 2 screws to fix the oven on
both sides (Detail A).
Warning! When you install oven next
to a heatproof and heat-insulating plate
mount heatproof and heat-insulating
plate at appliance's height and provide
a depth of at least 30 cm depth.
To secure the oven you can drill 2 x
2.8mm holes at the top where you can
find the indentations (detail C).
Electrical connection
Let a qualified electrician connect appliance
to the electricity supply. Use a H05VV-F
type power cable or higher. Install the appli-
ance with a socket supply line, otherwise
the fixed home electrical system must in-
clude an isolating device with at least a 3mm-
contact separation to enable a simultane-
ous and all-pole cut off from the mains (ac-
cording to NIN 2000). The customer must
have a socket for the electrical connection
that is accessible and outside the coordina-
tion room. The length of the connection ca-
ble must be approximately 120 cm with
lines connected direct to the mains.
1. Open the terminal box (detail D).
22 electrolux