Elta FT250 - Manual (Page 5)

Food product Baking temperature Duration
Chicken 170 °C 12 – 15 min.
Potatoes chips 180 °C 12 – 15 min.
Fish 160 °C 6 – 8 min.
Crabs 180 °C 6 – 7 min.
Mushrooms 150 °C 5 – 7 min.
Donuts 180 °C 5 – 6 min.
• The heating element (6) starts immediately heating the oil, at the desired temperature, inside the
fritter container (9). After this temperature is reached, the control lamp HEATING (4) stops
flashing. The food may now be put inside the fritter.
• Put the food inside the fritter basket (2). Do not overfill the fritter basket (2), or the food will not be
baked as desired.
• Open carefully the top cover (1) by the handhold (12). Catch the fritter basket (2) by the handhold
(11) and insert it slowly in the fritter container (9), together with the food. Pay attention to the
grease splashes and the ascending foam. The grease should not pass over the edge.
• Close down the top cover (1) by the handhold (12).
• The device is equipped with an incorporated Thermostat. The control lamp HEATING (4) will
therefore, meanwhile, flash up and then stop flashing again. This means that the device heats the
oil rapidly, for keeping the temperature constant.
• Open carefully the top cover (1) by the handhold (12). Attention: Hot vapors
and possible splashing grease could cause flash burns!
• Take the fritter basket (2) by the handhold (11) out of the fritter container (9).
Hang the fritter basket support on the edge of the fritter container (9). Leave
the grease drip down.
• Switch the temperature controller (5) on the position OFF. Pull out the power
plug (7).
• The food can be taken out of the fritter basket (3).
• Leave the oil cool down.
Overheating protection
• The fritter is equipped with an overheating protection. When the fritter cannot be switched on,
check if the overheating protection was activated. Pull the power plug (7) out of the socket outlet
and press with a peaked object on the RESTART key.
CLEANING AND TENDER
• Pay regard to the Security advice.
• Before cleaning, always leave the device and its content
cool down.
• The device has to be cleaned after each baking process,
because the food residues are highly combustible and oil
or grease become therefore more quickly rancid. Take out
at least the residues in the remaining oil.
• The oil should be renewed.
• For cleaning, take out the control unit, together with the
heating elements.
• Clean the control unit and the heating wands with a
moistened cloth. Attention! Never dive the control unit
and the heating elements into water.
• Clean the exterior case and the top cover (1) with a cloth moistened with water and use mild
detergents.
• Clean the fritter container (9) with hot water and washing up liquids; rinse finally with warm water.
• The fritter basket (2) can be cleaned with hot water and washing up liquids.
• Do no use scrubbing detergents or tough cleaning utensils.
• Do not use by any means gasoline or solvents for cleaning.
TECHNICAL DATA
Operational voltage: 230V~ 50Hz
Power consumption: 2000 Watt
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its life cycle;
hand it over at a collection point for the recycling of electrical and electronic appliances.
The symbol on the product, the instructions for use or the packing will inform about the
methods for disposal.
The materials are recyclable as mentioned in its marking. By recycling, material recycling or other
forms of re-utilization of old appliances, you are making an important contribution to protect our
environment.
Please inquire at the community administration for the authorized disposal location.
GUARANTEE AND CUSTOMER SERVICE
Before delivery our devices are subjected to rigorous quality control. If, despite all care, damage has
occurred during production or transportation, please return the device to your dealer. In addition to
statutory legal rights, the purchaser has an option to claim under the terms of the following
guarantee:
For the purchased device we provide 2 years guarantee, commencing from the day of sale. During
this period we will remedy all defects free of charge, which can be demonstrably attributed to
material or manufacturing defects, by repair or exchange.
Defects which arise due to improper handling of the device and malfunctions due to interventions
and repairs by third parties or the fitting of non-original parts, are not covered by this guarantee.
7 8
RESTART key
MAX
MIN
Control unit
GB GB GB GB
approved
elta GmbH
Carl-Zeiss-Str. 8
63322 Rödermark