EverFocus EDSR100M - Manual (Page 10)

Connect the Camera
Connect the power connector from the camera harness into the CAM ERA POWER OUT jack on the back panel
of the DVR.
Adjust the camera. After the camera is installed, connect a monitor directly to the camera and observe the image.
Make any adjustment necessary.
Installing the Camera and Monitor
The DVR is typically connected to one camera installed inside the car.
For installation procedure, refer to the guide
that came with the camera you purchased.
The Monitor power supply connect from the Automotive adapter(cig arette plug)
Monitor and cameras must be purchased separately.
LCD Monitor
LCD Monitor
Quick Install Guide