Energy Tech Laboratories VEC1029FPOB - Manual (Page 13)

12
Fuse Replacement (12 Volt DC Charging/Power Adapter)
1. Remove plug from accessory outlet. Remove the gold cap by turning counter-
clockwise and lifting off.
2. Remove center pin and spring. Remove fuse.
3. Replace fuse with same type and size fuse (8 amp).
4. Replace center pin and spring inside plug.
5. Replace gold cap by turning clockwise.
Battery Replacement/Disposal
It is recommended that the unit be returned to Customer Service for
battery replacement.
This unit contains a maintenance-free, non-spillable, sealed lead-acid
battery. This battery is fully recyclable and should be accepted at any
location that accepts common automotive batteries. Examples of places
that accept these batteries are: county or municipal recycling drop-off centers, scrap
metal dealers and retailers who sell automotive replacement lead acid batteries.
WARNINGS
Do not dispose of the battery in fire, as this may result in an explosion.
Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to
prevent shorting (shorting can result in injury or fire).
Do not expose battery to fire or intense heat, as it may explode.
SPECIFICATIONS
12 Volt DC Specifications
Battery: 12 volt DC rechargeable, maintenance-free
Internal Battery Type: Sealed, AGM lead-acid
Internal Battery Capacity: 12 volt, 19Ah/20 hour rate
Area Light : Light Emitting Diode (LED)
Accessory Outlet Protection: Self-resetting overload protection
DC Charging Adapter: 12 volt DC
AC Power Specifications
Output Power: 400 watts
Output Voltage: 120 VAC RMS
Output Frequency: 60 Hz ±4 Hz
Output Waveform: Modified sine wave
Overheat Protection: Yes
Overload Protection: Yes
Output Short Circuit
Protection: Yes
VEC1029FPOB_ManualEN_101606 10/16/06 5:17 PM Page 12