Epson 4SLC2-50 - Manual (Page 107)

3.
4.
5.
6.
You may be able to resume activity by cancelling the current
operation (if you’re working in DOS). Try pressing Ctrl
C or
Ctrl B.
Try pressing NumLock. If the computer does not respond, it is
probably locked up.
If the computer remains locked up after you’ve waited and tried
the solutions listed above, reset it by pressing Ctrl Alt Delete.
If resetting does not work, you probably need to turn off the
computer, wait five seconds, and turn it back on.
Password Problems
If you set a password using the Setup program, you must enter it
at the times you selected in Setup: either whenever you start or
reset the computer or whenever you start the Setup program. If
you have trouble using your password, try the following:
1. If you type the password and then see an X, type it again and
press Enter. If you type it wrong three times, the computer
locks up. Press Ctrl Alt Delete to reset the computer and try
again.
2. If you know the current password but you want to change it,
see Chapter 5 for instructions.
3. If you have forgotten your password, call the Epson Connection
for assistance.
A-8 Troubleshooting