Elmo ESD-CC1 - Manual (Page 19)

4.3.10 Key Press Beep
The built-in buzzer will beep when the user press any valid key, this item allow you to turn the beep on or off. Use "◄"
or "►" key to change the setting.
4.3.11 Alarm Reaction
When the alarm input of the dome camera is triggered, the camera will send an alarm message to the keyboard. The
keyboard can be programmed to react to the message by: 1. Buzzer beep, 2. link to that camera automatically (so operator
can control that camera immediately), 3. switch the multiplexer to that channel in full screen.
These reactions are disabled (OFF) by default. Menu 1.5 allows you to enable (ON) this function. Use "◄" or "►" key
to change the setting.
4.3.12 Password Set
This item allows you to change the password, you have to enter the same number twice to confirm the change.
4.4 Multiplexer Control
Under any mode, hit Multiplexer control key and input the Multiplexer’s number then hit “ENTER” key (as Fig.4.4.1).
Then, you can remotely control that particular Multiplexer. Please refer Multiplexer’s manual to get the method of control
and setting.
4.5 The control and setting of Video Matrix Switcher
It is reserved now.
Under any mode, you can hit “Matrix” hot key to remote control the video matrix switcher. You can hit
“ENTER” key to enter OSD control mode. You can hit “Direction”, “ENTER” and “ESC” keys to set all
programs of Matrix. Please reference the Matrix’s manual to get the detail definition of Matrix.
1.10 Key Press Beep
[OFF] ON
Fig.4.3.10
1.12.1 Password[****]
Fig.4.3.12.1
1.12.2 Password[****]
Confirm [____]
Fig.4.3.12.2
1.11 Alarm Reaction
[OFF] ON
Fig.4.3.11
Multiplexer mode
Select MPX(1-16):xx
Fig.4.4.1
< Multiplexer> MPX:xx
Select Camera CH:xx
Fig.4.4.2
19