DE DIETRICH DLZ614BE1 - Manual (Page 39)

PROGRAMME
PHASES
85
When the programme is running, the
programme phase and the time remaining for
it to end will appear on the display..
The active phases will appear successively at
the top of the display as the programme
progresses. The time remaining until the end
of the programme will also appear on the
display. It updates at regular intervals, but not
minute by minute.
Any option button can be selected provided
the wash phase in which it takes effect has
not been passed and when the programme
accepts the option.
Pressing the delay button during washing will
have no effect on the washer.
Pressing the Start/Stop button during the wash
activates the PAUSE function.
5
WASH PROGRAMME PHASES
AND POWER CUTS
using the appliance and practical tips
Important
warnings
All the models have a safety system for spin-drying
that prevents spin-drying from being carried out if the
distribution of the clothes inside the drum is too
concentrated. This prevents the appliance from vibrating
too much.
If you find that the clothes are not properly wrung out,
try spin-drying them again after having distributed the
clothes more evenly in the drum.
Level the washing machine by adjusting the
feet to reduce the noise caused by spin-drying.
Try and wash clothes of different sizes in
the same wash programme to favour the
distribution of the clothes inside the drum
during spin-drying.
If the programme is changed on the selector
dial during the washing and drying process,
the washer will go onto PAUSE status and
the programme will be cancelled.
If you need to add or remove a garment, press
the Start/Stop button and make sure that the
water level is not above the door overflow
level and that the temperature inside is not
high. Press the Start/Stop button again to
restart the wash from the same cycle phase
it had stopped at.
If there is a power cut, when the electricity
comes back on the washing machine will
continue to run from where it left off (it has
several hours of memory). The same will
happen if the ON/OFF button is pressed.
POWER CUTS