DE DIETRICH DVH610 - Manual (Page 8)

20
EN 2 / INSTALLING YOUR DISHWASHER
• FITTING THE DOOR PANEL
(Cladding with a single panel)
- Measure the distance between the floor and
the bottom of the door panel on the adjacent
unit (Dimension B, Fig. 5.1)
- Measure the distance between the floor and
the marking on the bottom of the door panel
(Dimension A)
- Calculate Dimension D = A - B, and draw a
line for Dimension D on the back of the panel
at the bottom (Fig. 5.2)
- Set the positions for the two screws at
262mm from the wood panel’s axis and insert
two screws
. (Fig. 5.2)
- Position your door panel by engaging the 2
screws in the holes in the dishwasher’s door
(Fig. 6.1)
- If there is a problem with screwing, offset the
screw
by 22 mm.
- Place the wood panel flat against the door
(Fig. 6.2).
- Open the dishwasher’s door while holding
the panel flat up against the door. Centre the
wood panel at the sides with respect to the
control panel, if necessary. Insert the 2
screws
and the 4 screws (Fig. 6.2).
Warning :
If the wood panel is very hard, ensure
that you make a hole in advance before scre-
wing the panel on.
NB :
If your appliance is supplied with a
sound insulation sheet, glue this on before
installing the door panel.
P P8 8 P P7 7
P P6 6
P P6 6
D
D
262
262
✍
Fig. 6.1
Fig. 6.2
Fig. 5.2
D=A-B
B
A
(22)
B
Fig. 5.1