Building-in, Electrical connection – DE DIETRICH DFS511JE1 User Manual

Page 9

Advertising
background image

21

This appliance complies with the following E.E.C.
Directives:

- 87/308 EEC of 2/6/87 relative to radio

interference suppression.

- 73/23 EEC of 19.2.73 (Low Voltage
Directive)

and subsequent modifications.

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent
modifications.

Attention!

It must be possible to disconnect the appliance

from the mains power supply; the plug must
therefore be easily accessible after installation.

Building-in

Dimensions of the recess

Height of housing (1) 880 mm
Depth of housing (2)

550 mm

Width of housing (3)

560 mm

It is necessary that the niche is provided with a
conduct of ventilation having the following
dimensions:
Depth

50 mm

Width

540 mm

PR0

540

50

3

2

1

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.

Important
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.

If the domestic power supply socket is not
earthed. connect the appliance to a separate
earth in compliance with current regulations,
consulting a specialist technician.

The Manufacturer declines all
responsibility if the above safety
precautions are not observed.

D022

1

2

1. Fit the appliance in the niche by making sure that it

stands against the interior surface of the unit on the
side where the door hinges of the appliances are
fitted. Insert the appliance until the upper strip butts
up against the unit (1) and make sure that the
lower hinge is in line with the surface of the unit (2).

D132

2. Apply joint the sealing strip as shown in figure.

Advertising
This manual is related to the following products: