Electrolux 985 - Manual (Page 11)

FITTING INTO THE CABINET
IMPORTANT: Ensure that the oven is switched
off at the wall before any further work is carried
out.
l
Using a tape measure establish the internal width
of the cabinet. Refer to page 7 if greater than
565mm.
l
Position the appliance in front of the cabinet. See
Fig. 7.
l Take out all oven furniture before installation to
reduce the weight you need to lift. The oven door
should be taped up to keep it closed whilst lifting.
l
To place the appliance into the cabinetry follow
the procedure below:
l
N.B. Two people will be required to carry out
the lifting procedure.
a) Each person should squat either side of the
appliance.
Warning: Do Not attempt to lift this
appliance by the handles.
b) Tilt the appliance so that your hands can support
the underside of the appliance.
c) Keeping your back straight, raise the appliance to
the cabinet by straightening at the knees.
d) Rest the rear underside of the appliance on the
cabinet floor while your hands support the front.
e) The appliance can be pushed fully into the
cabinet. Take care to avoid damaging the mains
lead.
f) Ensure the appliance is central in the cabinet and
level.
g) Do not remove spacers fitted behind fixing holes.
h) When the appliance is fully housed screw the
stability screws (supplied with the appliance) into
the side of the cabinet taking care not to distort
the side trims (See Fig. 8). It is advisable to turn
each screw alternately to avoid damaging the
trims.
i) Switch on the appliance then refer to the
operating instructions in the following pages.
Fig.7
Fig.8
Mains
Cable
Pack Base
11