Amprobe ACD-330T Clamp-On-Multimeter - Manual (Page 41)

WARNING
TO AVOID ELECTRICAL SHOCK, DO NOT PERFORM ANY SERVICING
UNLESS YOU ARE QUALIFIED TO DO SO.
SERVICE
If the instrument fails to operate, check battery, test leads, etc. and replace as nec-
essary. If the instrument still does not operate, double check operating procedure as
described in this instruction manual. When servicing, use only specified replace-
ment parts.
WARNING
TOAVOID ELECTRICALSHOCK OR DAMAGE TO THE METER, DO NOT
GET WATER INSIDE THE CASE. REMOVE THE TEST LEADS AND ANY
INPUTSIGNALS BEFORE OPENING THE CASE.
BATTERY REPLACEMENT
The meter is powered by a single 9V battery, with NEDA1604, S006P,IEC6F22
carbon-zinc alkaline, or similar battery. Replace battery if the low battery sign ( )is
displayed and flashing. Use the following procedure to replace the battery:
1. Remove the meter from the circuit and turn the rotary switch to the
OFF position.
2. Disconnect the test leads from the instrument.
3. Loosen the screw on the battery cover.
4. Pull the cover up slightly and slide the battery cover off (see Figure
24 and Figure 25).
5. Replace the defective battery.
6. Reverse the procedure of opening cover to close the battery cover.
CLEANING
To clean the instrument, use a soft cloth dampened in a solution of mild detergent
and water. Do not spray cleaner directly onto the instrument, since it may leak into
the cabinet and cause damage.
Do not use chemicals containing benzine, benzene, toluene, xylene, acetone or sim-
ilar solvents.
MAINTENANCE
37