Amprobe ACD-20SW Digital-Clamp-Meters - Manual (Page 7)

2
SYMBOLS
 Battery W Refer to the manual
T Double Insulated
J
Earth Ground
B Alternating Current I Fuse
F Direct Current P Complies with EU directives
,
Application around and
removal from hazardous live
conductors is permitted
;
Conform to relevant
Australian standards
=
Do not dispose of this product
as unsorted municipal waste
m Audible tone
)
Canadian Standards Association (NRTL/C)
Safety Information
• The ACD-20SW, ACD-21SW and ACD-21SWC swivel Clamp meters conform
to EN61010-1:2001; EN61010- 2-032:2002; CAT III 600 V, class II; pollution
deg.2 and EN61326-1 (EMC compliance)
• This instrument is EN61010-1 certified for Installation Category III (600V).
It is recommended for use in primary supply lines, overhead lines and
cable systems and distribution level and fixed installations, as well as lesser
installations.
• Do not exceed the maximum overload limits per function (see
specifications) nor the limits marked on the instrument itself. Never apply
more than 600 V ac rms between the test lead and earth ground.
W
Warnings and Precautions
• Before and after hazardous voltage measurements, test the voltage
function on a known source such as line voltage to determine proper
meter functioning.
• Disconnect the test leads from the test points before changing meter
functions.
• Disconnected from the meter’s test leads before measuring current.