Amprobe GSD600 Gas-Leak-Detector - Manual (Page 6)

5
GWD600 FEAtURES
Detects methane and propane gas •
quick to pinpoint gas leaks •
Automatic calibration when power is on •
Auto power off to save battery life •
60 seconds warm up time •
Response time less than 10 seconds •
5-level LeD leak alarm •
440 mm long flexible probe •
built in earphone jack •
Mute function •
StANDARD ACCESSoRIES
1x instrument GSD600
4x AA batteries
1x Users Manual
opERAtIoN
power oN/oFF pushbutton
press on/off key for more than two seconds to turn on the meter. while the meter is on, •
the bAT. oK LeD will stay on.
To ensure the accuracy, users must perform the warm-up period in clean air.
•
The meter automatically turns itself off if no pushbutton is pressed for ten minutes. •
press on/off key again to turn the meter off. •
Warm-up Status
when the meter is on and ReADY LeD is off, the sensor enters into a warm-up process. The •
warm-up time is less than 60 seconds.
when Ready LeD is on, the meter is ready to be used.
•
During that period of warm-up, a special compensation circuit automatically limits the effect •
of the environmental changes.
Any time you turn the unit off and turn it back on, it will go through the warm-up process
again. Wait for 60 seconds.
Mute Function
The frequency of the beep will increase when the detected gas concentration becomes higher.
while using the meter with the earphone, the meter will automatically be muted, allowing the
user to hear the beeper through the earphone. The earphone is not supplied with the GSD600.
A standard earphone will work with this unit.